Start Charging; Switching The Display - AEG 97015 Mode D'emploi

Start charging

1. Repeatedly press the „V" button (1) to select the
desired charging mode, 6 V or 12 V. The LED will
indicate your selection.
Note:
If an incorrect charging mode was selected, the
"Error" LED (9) will light up. In this case unplug the
charger, wait briefly, and plug in again.
2. The charging process will start automatically.
The "Charge" LED (11) will light up throughout
the charging process.
3. The battery is fully charged when the "Full" LED
(10) lights up and the "Charge" LED (11) goes
out.
Note:
Once the battery is fully charged, the charger will
switch to trickle charge to maintain the charging
status and protect the battery from overcharging
LD 5.0 and LD 7.0 Microprocessor charger only:
•
The display will show 100 and the LED „%" will
light up.
•
Use the „V / A / %" (2) button to switch the dis-
play during charging (see "Product overview").

Switching the display

During the charging process you can repeatedly
press the „V / A / %" button (5) to display the
following parameters:
•
V = charging voltage
•
A = charging current
•
% = battery charge condition
English 29