Functions; Operation; Before Use - AEG 10616 Mode D'emploi

No. Description
1 Display
2 "Mode" button
3 Comfort plug connection
4 Terminal connection cable (+) with clamp (red)
5 Terminal connection cable (-) with clamp (black)
6 Terminal connection cable (-) with ring lug (black)
7 Terminal connection cable (+) with ring lug (red)
8 Power cable with power plug
9 Mounting option

Functions

The charger is equipped with a microprocessor
(MCU - Micro Computer Unit) and features fully
automatic charging-, diagnostic-, emergency-
and maintenance functions. After selecting the
connected battery (6 V, 12 V or 24 V) the charger
will recognise the battery capacity and the battery
condition and calculate the required charging pa-
rameters (charging voltage, charging current). This
allows for efficient and safe charging. When selec-
ting a charging mode not suitable for the battery or
if the battery is defective, the charging cycle still not
start. The charger switches to error indicator.
After a mains failure the charger automatically
restarts and returns to the previous charging mode.
The "trickle charge" function allows the charger
to be permanently connected. A full charge will be
maintained.

OPERATION

Before use

Warning!
Before using this device be sure to read the ope-
rating manual for the battery and the vehicle and
understand all safety notices.
•
Use safety goggles and acid-proof safety gloves.
•
Ensure adequate ventilation.
•
Ensure the battery poles are clean. If the battery
has removable vent caps, fill each battery cell with
distilled water to the level recommended by the
battery manufacturer. Do not overfill the cells.
•
If the battery must be removed from the vehicle
before charging, always disconnect the earthed
connector from the battery first. Also ensure all
other loads in the vehicle are off.
•
If the battery does not have caps, refer to the
manufacturer instructions on charging and the
charging speed.
English 25