Maintenance And Care; Declaration Of Conformity - RHINO BE 35 BLACK Manuel D'utilisation

3. MAINTENANCE

3.1 Maintenance and care

• Rinse the motor thoroughly with running water.
• The screws and moving parts of the motor suspension should
be lubricated with environmentally friendly oil approx. every
two weeks.
• The electrical connections should be checked monthly for
corrosion. Replace defective connections or cables immediately
to avoid possible overheating.
• For longer-term storage, make sure to keep the motor in a
well-ventilated, dry place.
• Do not leave the motor outdoors during the winter, as this
could cause damage to the magnet of the drive unit. .
3.2 Troubleshooting
Power loss
• Propeller possibly sti . Check if line or weeds are caught in
the screw.
• Check the charge level of the battery. Check the battery cells.
• Check the connections of the battery cable.
Power consumption too high
• Check propeller for sti ness.
• Corrosion or short-circuit at cable connectors in the upper
motor housing
• Check the battery cells.
6
Motor noise too loud and/or vibrations
• Check t and condition of the propeller; if necessary remount
the propeller o set by 180°.
• High frequency noise at propeller shaft. Remove the propel-
ler, lubricate the propeller shaft with a light oil, if necessary
let it work longer.
• Bent shaft. Remove the propeller and run the motor at
medium speed, paying attention to shaft noises.
• If the shaft is bent, send the motor in for repair.
• Turn the propeller by hand, in case of sti ness send in the
motor for servicing.
Motor is di cult to steer
• Loosen and readjust the steering tension block screw and
apply some grease.
For all other problems not listed here, please
contact your dealer or Zebco Service

4. Declaration of Conformity

7