EHEIM powerLED+ Mode D'emploi page 11

English
‧ If they are not being used, always disconnect all
devices in the aquarium from the power supply before
you install/remove any parts and before all cleaning and
maintenance work.
‧ Protect the mains socket and
mains plug against moisture and
wetness. A drip loop must be
formed with the mains cable.
This prevents any water running
along the cable to the mains
socket, which would result in a
short-circuit.
‧ The electrical data of the appliance must match the
data of the power mains. This data is found on the type
plate, the packaging and in these instructions.
‧ The distance from the underside of the light to the high-
est water mark must be a minimum of 15 mm.
Commissioning
Installation (⌦A)
1. The LED lights can be adjusted to the width
Electrical connection
1. Connect the plug of the LED lights to the
The matching EHEIM power supply unit can be
found on the packaging of your LED light.
Operation
Service life
In order to avoid excessive algae formation,
you should not put the LED lights in continuous
operation.
Optional accessories
Use with Y distributor
The Y distributor allows you to operate two LED lights from
one power supply unit.
Ensure that the maximum power output of the
power supply unit is not exceeded (see Techni-
cal Data, page 96)
Use with T5/T8 adapter
With the T5/T8 adapter, you can replace traditional fluores-
cent bulbs with an LED light. To do so, proceed as follows:
1. Push both adapter parts together
onto the extendable bracket
DANGER! Electric shock!
▶ Before all assembly work, remove the mains
▶ Keep the lighting unit or cover disconnected
▶ Secure the mains plug of the lighting unit or
2. Loosen the end cap
bulb.
of your aquarium with the freely adjustable
extendable bracket
ble bracket out of the light housing until it
reaches the desired length.
socket of the matching EHEIM power supply
unit.
plug of the lighting unit and or cover.
from the mains!
cover against any unintentional connection
to the socket
⑤
. Pull the extenda-
①
②
(⌦C).
①
and remove the fluorescent
11
/ until they click
③