Remote Blower Preparation - Zephyr Okeanito COK-E36CSX Guide D'utilisation, D'entretien Et D'installation

Installation Instructions

Remote Blower Preparation

1. Remove internal blower flange
from motor housing by (6) screws.
4. Secure ground wire from remote
blower wiring to ground wire rivet
nut.
14
2. Install remote blower 8" round
collar. Attach by (4) M4*8 screws.
5. Connect 6 pin male connector
from remote blower wiring to 6
pin female connector on control
board box.
Okeanito Use, Care, and Installation Guide
D E S I G N E R
O K E A N I TO
3. Install threaded cable lock and
remote blower wiring harness
through the remote blower wiring
knockout. Attach by (4) M4*8
screws.
NOTE: For instructions on mounting
the remote blower, please refer to
the CBE-1000 or PBN-1000A remote
blower manual included in the remote
blower packaging or on our website at
www.zephyronline.com
WA L L