Optional Rf Remote Control - Zephyr Siena Pro Island ZSL-E42CS Guide D'utilisation, D'entretien Et D'installation

ZEPHYRONLINE.COM

Optional RF Remote Control

To enable RF remote control capabilities, the remote control accessory kit is required. The part
number for the kit is RC-0002.
FCC Caution
To assure continued compliance, any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment. (Example -
use only shielded interface cables when connecting to computer or peripheral device. This device
complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions. (1)
This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
Installation
To install remote control accessory kit, please follow these steps below.
1. Remove baffle filters.
2. Remove 3 screws attaching internal cover panel.
3. Connect the red wiring from the remote control control board to red connector in hood PC board.
4. Adhere remote control control board near PC board box.
5. The blue antenna wire needs to be extended for optimal signal. There is no need to secure it.
Synchronization
To create a unique link between your hood and remote control please follow these steps.
1. With hood off, press and hold the Lights button on the hood until the controls illuminate and flash.
2. Press a button on the remote, and the remote control will be synchronized with the hood.
RF Remote Control Functions
Blower On/
1 2
Speed Selection
3
4
Lights On/Dim/O
5 Min Delay O
Siena Pro Island Use, Care, and Installation Guide
Blower On/
Power O
Blower On / Speed Selection
1
Press
Blower On / Power O
2
By pressing
again and the entire hood will power o , including lights.
Delay O
3
By pressing
change to speed 1 and a 5 minute timer will begin counting down.
Lights On/Dim/O
4
Switch between light levels by pressing
the di erent light levels.
Features & Controls
to power on blower and cycle through all speeds.
, the blowers will power on at the last speed setting. Press
, the blower and lights will enter Delay O mode. The blower will
. Turn o the lights by cycling through
19