Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
E.
Connect the supply power conductors to the "A" and
"N" lugs on the connection strip. IMPORTANT – If
power is from one "Hot" and one "Neutral"
conductor, connect the neutral to "N". Connect the
ground conductor to the "ground" lug (See Figure
10).
F.
Plug the air conditioner electrical conduit into the 9
position receptacle as shown in Figure 10.
G.
If the optional heater accessory package is being
installed, remove the cover from the 2 position
receptacle and plug the heater cord into receptacle
as shown in Figure 10.
H.
Raise the ceiling assembly chute to the unit mounting
frame and secure the chute with 4 provided screws
(See Figure 11).
TIE ALL WIRING TO INSURE NO CONTACT
I.
WITH ANY SHARP EDGES OR WITH THE
OPTIONAL HEATER. KEEP IN MIND THAT
HIGH VELOCITY AIR WILL BE
ENCOUNTERED IN THIS AREA.
J.
Pull the fabric duct material through the ceiling
chute discharge opening. Peel the release liner
from the adhesive strip around the opening.
Press the fabric duct material firmly in place
around opening. Cut off excess fabric on
inside of ceiling chute with a box knife taking
care not to tear the fabric beyond the adhesive
strip.
K.
Raise the ceiling shroud and while insuring it
meshes with the chute, secure to mounting
frame with 4 provided screws (See Figure 11).
L.
Install the control knobs over the switch and
thermostat shafts. The thermostat (temperature)
control knob installs nearest the "Coleman-
Mach" logo. If the optional heater accessory is
installed, use the selector switch knob that
indicates "Low Heat" with a red fan symbol,
otherwise use the knob with a white fan symbol
indication in this position.
M.
Re-install the filters and grilles into the ceiling
assembly shroud.
N.
Turn the selector switch to OFF position.
O.
Turn ON the power supply to the roof top air
conditioner.
FIGURE 10
10
Publicité
Chapitres
Table des Matières
