Installing The Optional Heater Accessory - Airxcel 8000 Serie Mode D'emploi

SHEATH CABLE IS CENTERED IN
CLAMP BEFORE TIGHTENING UP
ON IT. DO NOT OVERTIGHTEN!!
THIS COULD RESULT IN PINCHING
THROUGH THE PLASTIC WIRE
INSULATION AND CAUSE SHORTING
OR "HOT" WIRES TO GROUND
(SHOCK HAZARD). THE CLAMP IS
INTENDED FOR STRAIN RELIEF OF
THE WIRES. SLIGHT PRESSURE IS
USUALLY SUFFICIENT TO
ACCOMPLISH THIS.
IF OTHER THAN NON-METALLIC
CABLES ARE USED FOR SUPPLY
CONDUCTORS, APPROPRIATE
STRAIN RELIEF CONNECTORS OR
CLAMPS SHOULD BE USED.
VII. INSTALLING THE OPTIONAL HEATER ACCESSORY
NOTE
The optional Heater Accessory is intended to take
the chill out of the indoor air when the air is a few
degrees too cool for comfort. The Heater
Accessory is an effective "chill chaser". It is not
a substitute for a furnace.
FIGURE 5
IN NO CASE SHOULD CLAMPING
OR PINCHING ACTION BE APPLIED
TO THE INDIVIDUAL SUPPLY LEADS
(NEUTRAL AND "HOT" WIRES).
SHOCK HAZARD
TO PREVENT THE POSSIBILITY OF
SHOCK INJURY, THE WHITE WIRE
MUST BE CONNECTED TO NEUTRAL
IN THE SERVICE BOX ENTRANCE,
AND THE MECHANICAL GROUND
MUST BE CONNECTED TO A
GROUNDING LUG EITHER IN THE
SERVICE BOX OR THE MOTOR
GENERATOR COMPARTMENT.
If the 9470*4551 heater option is being installed, position the
heater assembly in the air conditioner return air opening as
shown in Figure 5. The heater bracket must be installed over
the metal basepan extrusion and positioned between the
basepan and the plastic drain pan (See Figure 6). Tighten set
screw to secure the assembly so as to prevent movement.
Replace the selector switch control knob on the ceiling
assembly with that provided with the optional heater.
7
DANGER
FIGURE 6