Installing Indoor Unit - Haier AC12CS1ERA Manuel D'utilisation Et D'installation

Installation Procedure
3. Installing brackets
Install the brackets with nuts, washers and spring
washers. (Fig.14)

4. Installing indoor unit

Reset the hex bolts as shown in Fig.15.
Apply the indoor unit to the brackets. (Fig.16)
Now, securely tighten the hex bolts in both sides.
5. Installing the drain hose
Select whether the drain hose will be connected to the left or right side.(Fig.2)
Insert the drain hose into the drain pan, then secure the drain hose with a nylon fastener.(Fig.5)
Wrap the insulation (drain hose) around the drain hose connection. (Fig.6)
Be sure to arrange the drain hose correctly so that it is leveled lower than the drain hose connecting port of the indoor
unit. (Fig.17)
Fig.17
Arrange the drain hose
lower than this portion
When drain hose is arranged backward. Secure the drain hose with the VT wire. (Fig.18)
Fig.18
VT wire hole
Pass the drain hose through here
Remove the hole cover.
Drain hose
OK
Piping hole
Base (Bottom)
Intake grill
Cut the grill
Fig.14A
Spring washer
Bracket
Special nut
Fig.15
Indoor unit
Fig.16
Drain hose
14
Fig.14B
Bracket (Left)
Bracket (Right)
Hex bolt
8 to 13mm
Bracket
Bolt
Indoor unit
NO
VT wire