How To Look After Your Hob - Brandt TI213BS1 Guide D'utilisation

99625701_ML_B.qxd 19/11/04

How to look after your hob?

Keeping your hob in good condition is easy if you clean it before it is completely
cold. Even so, never clean it when it is in use. Put all the electric and gas control
knobs at zero.
Looking after
sparkers and
injectors
Looking after
the grills and
burners
Looking after
your glass top
Looking after
your induction
rings
- It is better to wash the parts of your hob by hand rather than in a dishwasher
-Never use an abrasive sponge (Scotch-brite type) for cleaning your hob.
- Should a crack appear on the glass-top, disconnect your
appliance immediately and contact your After-Sales Service.
58
09:02 Page 58
HOW TO PROCEED
- If ever the sparkers
get dirty, clean them
with a stiff non-
metallic brush.
Nut
- The gas injectors
are in the centre of
each burner in the
form of a "pot".
thermocouple
Make sure not to
(depending on model)
block them up
partially when cleaning the hob, as this will
considerably reduce the performance of your
gas-rings.
- Use a non-abrasive cream for removing any
persistent stains. Then rinse with clean
water. Dry each burner element carefully
before re-lighting your hob.
- Clean it with hot water, then wipe dry. Use
special ceramic glass cleaning products for
any persistent stains.
- Clean them with hot water and wipe dry. If
necessary, finish off with the hard side of a
sponge and
Use special ceramic glass cleaning products for
any persistent stains. (See example below).
ACCESSORIES TO
Injector
Sparker
- Small hard-bristled
brush.
- Non-abrasive cream.
- Household sponge.
- Household sponge
- Special ceramic glass
products
E.g. Cera-Clen
- Household sponge
- Special ceramic glass
wipe dry.
products
E.g. Cera-Clen
BE USED