Locking Function; Stopping The Machine; Looking After Your Machine And Dealing With Faults; Cleaning The Machine - Brandt TI2SLIM Manuel D'instruction



Locking function

To lock all the control keys during cooking press the locking key (10). The "Lo" indicator will
appear on the screen.
In this situation only the Start/Stop key (7) can be used to turn off the machine. If you press
the Start/Stop key (7) in locking mode the screen will display "L" or "H" meaning that your
machine is turned off. To unlock the controls press the Start/Stop key (7) again and then press
the locking key for 3 seconds.
d) Stopping the Machine
After use the electric plate will be hot, the audible alarm sounds and the "H" indicator flashes
on the screen. To turn of the machine press the Start/Stop key (7) and then unplug it.
For information, you can refer to the following table to find the heating level relating to each
number on your control panel.
Level 1
Wattage left 120
side(W)
Wattage 120
right side
(W)

4) LOOKING AFTER YOUR MACHINE AND DEALING WITH FAULTS

a)

Cleaning the Machine

Ensure the machine is off and unplugged before cleaning.
Carry out cleaning when the ceramic plate has cooled down.
About the vitroceramic plate and the control panel

Lightly soiled: clean with a soft, damp cloth
 Soiled with fat: clean with a soft, damp cloth with a little toothpaste or neutral detergent
until the residues are removed.
 Do not use an abrasive, flammable, acid or alkaline cleaning liquid
Note: When cleaning never clean with surface of the hob with a stiff brush.
About the air inlet and the air vent
After a long period of use dust and other dirt may accumulate in the air inlet or the air vent.
The body of the induction cooker should be cleaned carefully with a clean, dry cloth. The dust
around the air inlet and the air vent must be cleaned with a supple brush or a cleaner.
2 3 4
300 500 800
200 400 500
5 6
1000 1200 1400
700 900 1000
25
7 8 9
1600 1800
1100 1300
10
2000
1400