Using The Functions; Frying Function - Brandt TI2SLIM Manuel D'instruction

In the same way if you place an incompatible pan on the plate the screen will show "E1" and a
beep will be heard. The machine will turn off automatically in the next 30 seconds.
c)

Using the Functions

 Simmering Function
To use this function press the Simmering key (2). An indicator light comes on above the key.
The heating power is adjusted to 2 by default. Pressing the +/- keys deactivates the mode.


Frying Function

To use this function press the Frying key (4). An indicator light comes on above the key. The
heating power is adjusted to 6 by default. Pressing the +/- keys deactivates the mode.
 Boiling Function
This function enables you to boil water. To use this function press the Boiling key (5). An
indicator light comes on above the key. The heating power is adjusted to 10 by default. After
about 7 minutes it turns itself down to 8 automatically. For this mode the heating time is set to
15 minutes. Pressing the +/- keys deactivates the mode.
Note: To avoid any risk of boiling over do not fill your pan to more than three quarters full.
 Boost Function
The Boost key (6) makes it possible to put the machine on full power for 10 minutes and then
maintain a maximum power level without the machine or the cooking utensil overheating. An
indicator light comes on above the key. Pressing the +/- keys deactivates the mode.
 "Keep Warm" (Maintien au chaud) Function
To keep your preparation at service temperature press the Maintien au chaud (Keep Warm) key
(1). An indicator light comes on above the key. The machine will automatically adjust itself to
the minimum power 1 and will stop after 120 minutes. To adjust the power again press the +/-
keys.
 Timer
In order to use the timer just select a cooking mode and then press the Timer key (3). An
indicator light comes on above the key. The digital screen will then show "00:00". Within 4
seconds press the +/- keys to adjust the cooking time. Each press increases or decreases the
time by 1 minute. If you hold down the key the time will increase or decrease by 10 minute
increments. The timer can be adjusted from 1 minute to 180 minutes. Once the time has
elapsed the digital screen will display "H" and a beep will be heard. The system will stop
automatically. To change the time during use press the Timer key (3) again and then press the
+/- keys. To stop the timer press the Timer key (3) for several seconds. The timer light will go
out.
24