Using Your Machine; Description Of The Control Panel; Starting The Machine - Brandt TI2SLIM Manuel D'instruction

 Protection against over-current or voltage anomalies. When the voltage is
abnormal or when the current is cut abruptly the induction cooker will stop to avoid any
damage. Once the problems have been dealt with the induction cooker will function
normally again.
 The pan detection system. If a pan is removed whilst the machine is in operation the
machine will stop heating. After that it will go on standby.
 Automatic switch-off. When the timer reaches the end of the time set the machine will
stop automatically until the user turns on the timer again. Similarly the machine will turn
off automatically if a dish being cooked has been forgotten for a long time.
 Locking the controls (10). This key makes it possible to lock all the controls to simplify
cleaning and also to protect children from any risk.

3) USING YOUR MACHINE

a)

Description of the Control Panel

 The control keys are touch-sensitive. There is no need to apply pressure.
 Use the base of your finger and not the tip as shown in the pictures below.
 Push the slider with your finger to increase or decrease the power,
 You will hear a beep each time an action is recorded.

The control panel must always be clean, dry and not covered by an object or a fabric.
Even a fine film of water may create malfunctions.
b) Starting the Machine
After having turned the machine on the audible alarm sounds and the screen displays "L" (cold)
or "H" (hot), indicating that the temperature of the induction plate is less than or higher than
60°C. Then press the Start/Stop key (7). The screen displays "----" meaning that the machine
is on standby and ready to be programmed. You can now use your induction plate.
Just press the + or - keys on your machine to select the desired power or use the slider directly
by sliding your finger from left to right or vice versa.
Never place an empty pan on the machine when it is in operation.
Note:
Once the machine is ready to be used, and if you don't press any other key during the next 30
seconds, it will turn off automatically after 60 seconds for safety reasons. The screen will show
"L" meaning that the machine's temperature is less than 60°C and is turned off.
23