Replace Stapling Head; Replace Driver Blade Or Return Springs - Josef Kihlberg F53 Mode D'emploi

Josef Kihlberg F53

7.6 REPLACE STAPLING HEAD

1. Loosen the links (15/1) and screws (15/2).
2. In order to loosen the rear screw (15/2) the stapli-
ng head must be lifted 90° .
3. Mount a new head and adjust as per (7/4).
4. Tighten the screws (15/2) and reassemble the
links.
5. Adjust the stapling head to the anvil as described
in chapter 7.5.
7.7 REPLACE DRIVER BLADE / RETURN SPRINGS
1. Remove the stapling head according to chapter
7.6.
2. Remove any staples from the staple track and
pusher to the front position.
3. Loosen the screw (Fig. 16/1). Squeeze the stapler
head and remove the staple trip block (16/3).
4. Driving down the lower part of stapling head until
the driver blade (16/5) are uncovered
5. Replace the driver and the return spring (16/6).
We recomend change driver blade and return
spring at the same time.
6. Assemble in reverse order. Please note that the
bevel at the driver blade must be turned to the
rear.
7. Assemble the stapling head to the machine as
described in chapter 7.6.
8. Adjust the stapling head as described in chapter
7.5.
12
1
Fig. 15
1 4
2 3
Fig. 16
2
5
6
02.15