Preventive And Corrective Maintenance; Lubrication; Cleaning The Industrial Stapler; Removing Jammed Staples - Josef Kihlberg F53 Mode D'emploi

Josef Kihlberg F53
7

7.1 LUBRICATION

The linkage bearings are greased at delivery.
At regular intervals (monthly) lubricate them with oil.
Also lubricate the moving parts in the stapling head
with a few drops of oil.

7.2 CLEANING THE INDUSTRIAL STAPLER

This Industrial stapler does not require special servi-
cing. It only needs regular cleaning with a non-aggres-
sive (non-corrosive) cleaning agent. Do not remove
any parts for cleaning purposes!
– Check if all screws and nuts are securely tighten-
ed.

7.3 REMOVING JAMMED STAPLES

– Loosen the screw (Fig. 11/1). Squeeze the stapler
head and remove the staple trip block(11/3).
– Driving down the lower part of stapling head until
the defective staple exposed.
– Remove the defective staple.
– Replace the driver (16/5) if it is worn.
– Assemble in reverse order.
10

PREVENTIVE AND CORRECTIVE MAINTENANCE

1
2 3
Fig. 11
02.15