Operating Instructions; Adjust The Stapling Gap - Josef Kihlberg JK35T590 Mode D'emploi

KUDA PACKAGING
6
1
Fig. 4
SERVIS A NAHRADNÍ DÍLY
06.14
www.kuda-packaging.com

OPERATING INSTRUCTIONS

During operation, the pliers' gap is fixed. If necessary
the gap can be set to accommodate different material
thicknesses. Spacers with 3 and 6 mm thickness are
available. These spacers are delivered with the tool,
together with a set of longer screws to be used when
spacers of more than 3 mm total are inserted.
– Unscrew the four screws (Fig. 4/1) and remove.
– Measure the work peace and add 1–2 mm.
– Adjust with 3 and 6 mm spacers so you receive
this space between the nozzle and the tounge.
– Check so the pliers can be moved easely at the
work peace.
– Adjust the anvil as described in chapters 7.4 and
7.5.
+420 607 237 237
Josef Kihlberg JK35T590
info@kuda-packaging.com

6.1 ADJUST THE STAPLING GAP

Be sure that the tool is not pointing at
yourself or anyone else when connec-
ting it to the compressed air line.
servis@josef-kihlberg.eu
7