Loading The Magazine; Operating The Stapler - Josef Kihlberg JK35T590 Mode D'emploi

Josef Kihlberg JK35T590
KUDA PACKAGING
6

6.2 LOADING THE MAGAZINE

Be sure that the tool is not pointing at
yourself or anyone else when connec-
ting it to the compressed air line.
– Connect the tool to the compressed air line before
loading staples. The max. allowed air pressure is
7 bar (102 psi)..
– Always use Josef Kihlberg original staples
JK590 with leg length 19 (3/4") to 32 mm
(1 1/4").
The correct type of staple is marked on the top
of the magazine cover. Ensure you use the right
length of staples for your application.
1. Pull the pusher all the way out. (Fig. 5/1)
2. Place two staple strips into the magazine from the
top (5/2)
3. Push the lock (5/3) and release the pusher. For-
ward it carefully until it reach the staples.

6.3 OPERATING THE STAPLER

Adjust the air pressure to the lowest one that will drive
the staples to the desired depth. Start at approx. 5.5
bar (80 psi) and raise this by 0.5 bar (7 psi) increase
until the correct operating pressure for the job in hand
is found. Never exceed 7 bar (100 psi).
A low air pressure will give low maintenance costs!
Always place yourself in a firmly balan-
ced position when using or handling the
tool. Do not drive staples at too steep
an angle or too close to the edge of the
work: the fastener might fly free and hurt
someone.
– Place the tool firmly on the work surface. Never
drive staples in extremely hard or brittle material.
Do not drive staples at too steep an angle or too
close to the edge of the work: the staples might fly
free and hurt someone.
Warning: before stapling, ensure that
your hand or any other part of your
body is not underneath/between the
nozzle and anvil.
– Pull the trigger as described in chapter 4,2
– Move the tolls sideway until you have finished and
then release the trigger.
– Control the clinch, refer to chapter 7.5.
SERVIS A NAHRADNÍ DÍLY
8
www.kuda-packaging.com
OPERATING INSTRUCTIONS
Fig. 5
+420 607 237 237
info@kuda-packaging.com
3
servis@josef-kihlberg.eu
1
2
06.14