Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
USER MANUAL
2.B
AIR LINE FITTINGS
Quick
release(Q/R)
Female
Air Connector
- Z749
Quick
release(Q/R)
Female
2.C
CONNECTING TO THE AIR SOURCE
Air Connector
- Z749
The machine should be connected to a pneumatic circuit providing 6 to 8 bars pressure.
Connect the machine
using
the
quick
connectors
as
mentioned
in
chapter I.2.B
The red knob in Figure 2-5 must be used to secure the machine during maintenance or to prevent non
desired use. A lock can be applied to it in stop position so nobody can turn it back to ON. This will exhaust air
from the machine circuit and disconnect it from air supply. Refer to chapter I.5.A
(page 19) for further instructions.
If the indicated pressure is not 6 bars (85 p.s.i.), check the pressure at the air source (compressor). Then, if pressure is correct at
the air source, it means the regulator of the machine needs fine tuning. Perform the following procedure to adjust it (Figure 2-6
and Figure 2-7)
Included in the machine
Standard hose connector - Z556
Q/R US male connector - Z701
Figure 2-4
Customer's air connection
The
CS200
CART
must be connected
to the air source
located on the front
panel of the drawer.
Turn the compressed
air valve to ON by
rotating its red knob .
The
air
pressure
gauge should show 6
bars
(85
p.s.i.)
minimum.
CS200 CART
Figure 2-5
SAFETY INSTRUCTIONS
10
Publicité
Table des Matières
