Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
USER MANUAL
3 ADJUSTMENTS
3.A
ADJUSTMENT OF THE SLIDING TABLE
The sliding table (see
page 5) needs to be
adjusted to be able to
set
the
various
stapling positions.
To do this, switch on
the Pre-Clamp button.
Install one moulding
on the table as per
picture attached.
Shift the sliding table
in order to tighten
the moulding with
the
rebate
clamp
(see page 5).
Then
tighten
the
sliding table handle .
3.B
PROPER ADJUSTMENT OF MAGNETIC ADJUSTABLE ROD CLAMP
A
magnetic
adjustable
rod
clamp comes with
your machine as a
standard
feature.
It fits the crossbar
thanks
to
the
locking ring and
can be set at 1 to 7
positions.
When adjusting the vertical rod clamp, closer it is from the top of the moulding, and faster will be
the machine. The machine will not damage the moulding, even if the distance is very close. If the
distance is superior to 50mm, the wedge will not penetrate fully inside the wood.
Unscrew the sliding
table handle.
Figure 3-1
Switch back off the
Pre-Clamp button in
order to release the
mouldings
remove
moulding that was
against
the
fence.
Figure 3-3
Pull the black knob
to be able to adjust
the space between
the
vertical
and the top of the
moulding. You must
have 50mm (2") max
between the clamp
and the top of the
moulding.
Figure 3-5
and
the
back
clamp
CS200 CART
Figure 3-2
Figure 3-4
Figure 3-6
12
Publicité
Table des Matières
