Joining The Frame - Cassese CS 200 CART Manuel De L'utilisateur

USER MANUAL

4 JOINING THE FRAME

Put The right side
moulding on the
table as per image.
Then push the
moulding until it
reaches the opposite
stop.
Put the second
moulding on the
table.
Press the pedal to
clamp the mouldings
together.
The horizontal
clamps will move up
to the moulding.
Rotate the joystick
and move it to the
second stop.
Release the pedal once the joining is done. It is possible also to shoot wedges (and even to stack them), between the two stops.
Rotate the joystick
and move it to the
desired stop. Joining
can be done starting
from inside
outside position.
Figure 4-1
Press the top button of
the joystick to insert the
wedge inside
moulding.
Keep the
pressed until
machine releases the
vertical clamp.
Press a second time the
button if another wedge
needs to be stacked in
this position.
pedal pressed during
Figure 4-3 this process.
Still with the
pressed, press the top
button of the joystick to
insert the wedge inside
the moulding.
Keep the
pressed until
machine releases the
vertical clamp.
Press a second time the
button if another wedge
needs to be stacked in
this position.
pedal pressed during
Figure 4-5
this process.
or
the
button
the
Keep
pedal
button
the
Keep
CS200 CART
Figure 4-2
Figure 4-4
Figure 4-6
18