Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
USER MANUAL
2 SETUP
2.A
UNPACKING THE MACHINE
Cutter
Flat span N.13 & N.17
Allen key N.5
Cut both plastic strips
in order to free the
box and lift up the
wood cover with the
help
of
a
second
person.
After unpacking the
machine, install and
set the 4 feet to level
the machine. Make
sure the 4 feet are
touching
the
floor,
machine
must
be
steady.
When levelling the machine, if the machine is installed against a working table, make sure a long frame will
not be risen up by the table, because this would cause bad joining. Working table and machine should be
levelled together.
When installing the machine, make sure the floor will be flat and strong enough to support its weight. It
should be installed in a dry environment providing temperate temperature. The floor should be flat and
clean. Select a location with proper lighting.
Bubble level
Remove the 4 bolts to
free
the
from the crate. They
are located under the
pallet.
Figure 2-1
Figure 2-3
machine
CS200 CART
Figure 2-2
9
Publicité
Table des Matières
