Aair Line Fittings; Bconnecting To The Air Source - Cassese MACH 4 UNI Mode D'emploi

USER MANUAL
When installing the machine, make sure the floor will be flat and strong enough to support its weight. It
should be installed in a dry environment providing temperate temperature. The floor should be flat and
clean. Select a location with proper lighting.
2.A AIR LINE FITTINGS
Quick
release(Q/R)
Female
Air Connector
- Z749
Quick
release(Q/R)
Female
2.B CONNECTING TO THE AIR SOURCE
Air Connector
- Z749
The machine should be connected to a pneumatic circuit providing 6 to 8 bars pressure.
Connect the machine
using the quick
connectors as
mentioned in
chapter I.2.A
The red knob in Figure 2-8 can be used to secure the machine during maintenance or to prevent non desired
use. A lock can be applied to it in stop position so nobody can turn it back to ON. This will exhaust air from
the machine circuit and disconnect it from air supply, but it WILL NOT switch off electrical components. Refer
to chapter I.7.A
Included in the machine
Standard hose connector - Z556
Q/R US male connector - Z701
Figure 2-7
SAFETY INSTRUCTIONS
The MACH 4 UNI
must be connected
to the air source
located on the front
panel of the drawer.
Turn the compressed
air valve to ON by
rotating its red knob .
The air pressure
gauge should show 6
bars (85 p.s.i.)
minimum.
(page 40) for further instructions.
Customer's air connection
MACH 4 UNI
Figure 2-8
11