Cassese MACH 4 UNI Mode D'emploi page 46

USER MANUAL MACH 4 UNI
>The sensor that informs the machine that the hammer is in the down position sends information that the hammer has not
returned down. Perform the procedure in chapter 7.C REMOVING THE DISTRIBUTOR HEAD (page 41).
The wedge breaks in the wood.
>The wood is too hard. Use special «hardwood» wedges.
>The backs are stained.
The distributor is full of grease.
>Perform the procedure described in chapter 7.C REMOVING THE DISTRIBUTOR HEAD (page 41) and remove any excess grease.
Do some stapling in scrap mouldings to purge any excess. Then wipe off the top of the distribution head.
Handling the mouldings is difficult.
The horizontal clamps are too tight against the mouldings. Repeat the pre-clamping procedure described in chapter I.4.A
ADJUSTMENT OF THE SLIDING TABLE (page 14).
The corners are crooked.
>Make sure to place the first moulding against stop as Figure 5-1.
>Make sure that clamping pressure is sufficient. Use the «clamp pressure» regulator on side of the machine to adjust it see
chapter 5.J USE OF REGULATOR (page 29).
46