Adjusting The Volume On The Door Video Module (Tvhs20000, Tvhs20010) - Abus MODUVIS TVHS20 Serie Manuel D'utilisation

Configuring the apartment number/residence number in the monitor:
In order to assign the call buttons in the residence to the correct monitors, the apartment
numbers for the monitors must match the call button numbers.
The apartment numbers for the respective monitor are displayed in the monitor's main overview.
You can either change the numbers directly in Configuration on the monitor
(configuration/apartment no.) or access the respective monitor using ABUS CMS software and,
in the menu "Intercom"/Room Number", change the apartment/residence numbers under
"room.No.:".
9.4

Adjusting the volume on the door video module (TVHS20000, TVHS20010)

Microphone sensitivity and voice volume on the door video volume can be adjusted using the
ABUS CMS software. You can also set or fully disable the confirmation tones/call tones/busy
signal volume.
Button/display
Volume In
Volume Out
Talk Volume
Description
Controls the microphone sensitivity for the door
video module. The higher the value, the louder
we will transmit voice to the monitor.
Controls automatic voice output (e.g.: leave a
message, call failed etc. This controller can
also be used to adjust the volume of
confirmation tones/call tones and busy signals.
(0 is completely mute)
Voice volume is adjusted here. The higher the
value, the louder the voice will be transmitted
from the monitor to the door station.
50