Setting Up Back Doors - Abus MODUVIS TVHS20 Serie Manuel D'utilisation

9.2

Setting up back doors

If you would like to integrate another door video module (maximum of 9) into the system to add a
back door (e.g.: receiving goods, cellar doors etc.), follow these steps:
1) Connect the door video module for the back door to the network for the main door
intercom station. All devices at the door intercom station must be located on the physical
LAN.
2) Open the ABUS CMS software and activate the door module for the back door.
3) Add the door intercom module for the back door in ABUS CMS software and open remote
configuration.
4) Now turn to "Room Number" under "Intercom". The numbers for the back door are entered
under "No.:". The main door video module must have the number "0". The additional
back doors will be numbered 1-9. Do not change the "Period/Building/Unit or Floor"
numbers.
After savings, the system will restart. Confirm by pressing "OK".
5) After successful restart, you will still need to assign the main doors for the back door. To
do this, enter and save the IP address of the main door station under "Network" /
"NetConfig SIP" under "(Main)Outdoor IP Address".
The menu "(Main) Outdoor IP Address" will only appear if you have properly
Attention:
completed step 4).
47