To Start The Product - Husqvarna 360BT Manuel D'utilisation

1. Fill half the quantity of gasoline in a clean
container for fuel.
2. Add the full quantity of oil.
3. Shake the fuel mixture.
4. Add the remaining quantity of gasoline to the
container.
5. Carefully shake the fuel mixture.
CAUTION:
than 1 month at a time.
To fill the fuel tank
WARNING:
that follows for your safety.
1. Stop the engine and let the engine become cool.
2. Clean the area around the fuel tank cap.
3. Shake the container and make sure that the fuel
is fully mixed.
4. Remove the fuel tank cap slowly to release the
pressure.
5. Fill the fuel tank.
CAUTION:
is not too much fuel in the fuel tank.
The fuel expands when it becomes
hot.
6. Tighten the fuel tank cap carefully.
7. Clean fuel spillage on and around the product.
8. Move the product 3 m/10 ft or more away from
the refueling area and fuel source before you
start the engine.
Note:
To see where the fuel tank is on your
Product overview on page 59 .
product, refer to
1750 - 003 - 03.03.2022
Do not mix fuel for more
Obey the procedure
Make sure that there

To start the product

1. If the engine is cold, push the choke lever to the
closed choke position. Refer to
product on page 60 .
2. Push the air purge bulb again and again until fuel
starts to fill the air purge bulb. It is not necessary
to fill the air purge bulb fully.
3. Push the start/stop switch with throttle control to
the 1/3 speed position. Refer to
throttle control/stop switch on page 66 .
4. Put the product on a flat surface on the ground.
5. Hold the product with the left hand.
CAUTION:
to hold the product.
6. Pull the starter rope handle slowly until
resistance occurs.
7. Pull the starter rope handle quickly with the right
hand. Pull the starter rope handle again and
again until the engine starts.
Note:
Do not pull the starter rope handle to full
extension and do not let go of the starter rope
handle.
8. If the engine is cold, push the choke lever to
the open choke position gradually until the choke
lever stops.
9. If the engine is cold, let the engine operate for
2-3 minutes to become warm before operation.
WARNING:
when the engine is started and when
the product is set at idle speed. Do
Symbols on the
To operate the
Do not use your feet
Air is released
65