Husqvarna 360BT Manuel D'utilisation page 68

2. Remove the screws (A), the screws (B) and the
exhaust duct (C).
3. Remove the spark arrester screen (D) and clean
it with a wire brush. Replace the spark arrester
screen if it is damaged.
4. Remove dirt from muffler and from the exhaust
port of the cylinder with the wire brush.
5. Attach the spark arrester screen (D) and the
exhaust duct (C) with the screws (B). Tighten the
screws to 2–3 Nm.
6. Tighten the screws (A) to 8–12 Nm. Make sure
that the muffler is correctly attached to the
product.
To examine and clean the cooling
system
The cooling system includes the cooling fins on the
cylinder and the air intake screen.
1. Stop the engine.
2. Make sure that the cooling system is not dirty or
blocked. If it is necessary, clean the air intake
screen and cooling fins.
CAUTION:
cooling system can increase the
temperature of the engine and cause
damage to the product. A clogged
air intake screen decreases the blow
force.
3. Examine the cooling system for damages. Make
sure that the parts are attached correctly to the
product.
To clean the air filter
CAUTION:
without an air filter or with a damaged air
filter. Dust in the air can cause damage
to the engine.
1. Push the choke control to the closed position.
2. Remove the air filter cover (A).
68
A
A
D
C
B
A dirty or blocked
Do not use a product
3. Remove the air filter (B) from the filter frame.
B
A
4. Clean the air filter with warm water with soap.
Note:
An air filter that has been used for a long
time cannot be fully cleaned. Replace the air filter
regularly and always replace a defective air filter.
5. Clean the inner surface of the air filter cover (A)
with a brush.
6. Apply oil to the air filter. Refer to
the foam air filter on page 68 .
7. Put the air filter in the filter frame.
8. Attach the air filter cover to the product.
To apply oil to the foam air filter
CAUTION:
special air filter oil. Do not use other
types of oil.
WARNING:
gloves. The air filter oil can cause skin
irritation.
1. Put the foam air filter in a plastic bag.
2. Put the oil in the plastic bag.
3. Rub the plastic bag to supply the oil equally
across the foam air filter.
4. Push the unwanted oil out of the foam air filter
while in the plastic bag.
To replace the harness
WARNING:
can make the product fall and cause
injuries. Make sure to install the clamp
correctly.
To apply oil to
Always use Husqvarna
Put on protective
A damaged harness
1750 - 003 - 03.03.2022