Starting And Stopping; Before Starting; Start The Machine; Use - Husqvarna TR262 Manuel D'utilisation

Before starting

•
Check the engine oil level and top up if necessary.
Illustration: 2 • 1
•
Check the oil level of the gear box, and top up if
necessary. Illustration: 2 • 2
• Check the fuel level. Fill if necessary. Illustration: 2 • 3
- Recommended to use: Octane Value over 90.
• Oiling the air filter Illustration: 2 • 4

Start the machine.

• Open the fuel tap. Illustration: 2 • 5
• Set the choke control in the A position. Illustration: 2 • 6
• Throttle control Illustration: 2 • 7
- Push the throttle control to full throttle position.
•
Set the on/off switch to ON to attain start throttle setting.
Illustration: 2 • 8
• Shifting lever Illustration: 2 • 9
- Put the gear shift lever in the "N" position (neutral).
• Pull the recoil start handle Illustration: 2 • 10
WARNING! When the machine starts, remain
!
in the safety zone
.
• Set the choke control in the B position. Illustration: 2 • 11

Use

WARNING! Keep unauthorized persons at a
!
distance. Children, animals, onlookers and
helpers should be kept outside the safety
zone of 20 m. Stop the machine immediately
if anyone approaches.

Forwards

Illustration: 3 • 1
•
Push down PTO lever to ON.
•
Use the shifting lever to control the drive speed.
Tilling speed
TILLING GEAR
•
Press down the trigger lock on the handle (A) and
push the clutch lever in towards the handle (B).
•
The cultivator starts to rotate when you push the
clutch down towards the handle and stops
rotating when you release the clutch.
–
6
English

STARTING AND STOPPING

•

Reverse

Illustration: 3 • 2
IMPORTANT! The cultivator starts to rotate when you push
the clutch down towards the handle and stops rotating
when you release the clutch. It is important to release the
clutch lever before using reverse.
•
Pull PTO lever up to OFF.
• Slide the control to "R" position.
REVERSE GEAR
WARNING! The use of reverse is dangerous!
!
Ensure that there are no obstacles behind
you and reduce the engine revs before
engaging the clutch.
•
Press down the trigger lock on the handle (A) and push
the clutch lever in towards the handle (B).
Transferring
Illustration: 3 • 3
•
Pull PTO lever up to OFF.
•
Use the shifting lever to control the drive speed.
WALKING GEAR
•
Press down the trigger lock on the handle (A) and push
the clutch lever in towards the handle (B).
•
To transfer the tiller in field and on road.

Stopping

• Release the clutch lever. Illustration: 4 • 1
• Put the gear shift lever in the "N" position (neutral).
Illustration: 4 • 2
NEUTRAL GEAR
•
Move the throttle control to the MIN. position.
Illustration: 4 • 3
•
Use the stop switch to switch off the engine.
Illustration: 4 • 4
• Close the fuel tap. Illustration: 4 • 5

Moving the machine

Illustration: 5 • 1
•
The engine must be switched off before moving. See
instructions under section Stopping.
•
Change the iron wheels to tyres and assemble the rear wheel
when transporting. (Figure A)