Assembling And Adjustments; Unpacking; Assembly; Description Of The Components - Husqvarna TR262 Manuel D'utilisation

Unpacking

Illustration: 1 • 1
IMPORTANT! Make sure to not cut the cables or scratch the
machine when cutting the edges of the case.
References Content of the case
A Engine parts
B Wheel axle
C Back tine cover
D Side cover, R
E Handlebar cover
F Iron wheel
G Tine assy, R
H Rear wheel
I Drag bar
J Wheel
K Tine cover
L
Shifting lever
M
Tidy cover
N Hardware bag
Tool bag
O

Assembly

Illustration: 1 • 2
WARNING! Inappropriate assembly of this
!
rotary tiller could cause severe injuries.
Ensure that you follow all the instructions
carefully.
• Fitting the handlebar. (Figure 1)
Fitting the wheels. (Figure 2)
•
• Fitting the tine cover. (Figure 3)
• Fitting the right tine assy. (Figure 4)
• Fitting the side cover. (Figure 5)
Fitting the drag bar and support wheel. (Figure 6)
•
Fitting the back cover. (Figure 7)
•
Fitting the shifting lever. (Figure 8)
•
Fitting the PTO lever. (Figure 9)
•
Fitting the handlebar cover. (Figure 10)
•
• Fitting the tidy cover. (Figure 11)
• Tidy the cables. (Figure 12)
- Put the cables through the holding spring.
- Fit the cables in cable clip.

ASSEMBLING AND ADJUSTMENTS

• Adjust the height of the handle by engage
the right lever. (Figure 13)
• Fitting the clutch control. (Figure 14)
- Turn to proper side and fasten the bolt.
Any dismantling operation must only be performed by an
authorized service workshop.
CAUTION! After assembling the machine completely, tighten
the bolts and screws with moderation. Do not overtighten.

Description of the components

Illustration: 1 • 3
1 Engine
2 Bumper
3 PTO lever
4 Shifting lever
5 Handlebar
6 Throttle control
7 Drag bar
8 Tine cover
9 Tine
10 Iron wheel
11 ON/OFF switch
12 Lever for handle height adjust
13 Clutch control

Type plate

Illustration: 1 • 4
1 Serial number
2 Article number
3 Tilling scope
4 Gear shifting
5 Engine displacement
6 Engine oil Quality (viscosity):
7 Engine oil capacity
8 Gear box oil quality
9 Gear box oil capacity
10 Nominal power
11 Net weight
12 Fuel

Transport wheel

Illustration: 1 • 5
Change the cultivator from working status to transporting
status. Change the iron wheel to tyre, assemble the rear
wheel.
For more information about moving of the machine, see
section "Moving".
– 5
English