LD Systems ROADMAN 102 Manuel D'utilisation page 13

SWITCHED OUT
6
Use this Output to plug a further passive speaker.
When using this output the speaker of the Roadman
102 is automatically muted and the sound only
comes out of the passive speaker. (min 4 )
UNSWITCHED OUT
7
Use this Output to plug a further passive speaker.
When using this output the sound comes out of both
the Roadman and the passive speaker. (min 8 )
LINK OUTPUT
8
This output allows you to connect the Roadman to
another Roadman.
LINK SET
9
MASTER / SLAVE: When connecting several Road-
man together (from 2 to max. 7) the Master / Slave
Order hast to be respected. First Roadman of the
"Chain" should be set on Master, the following ones
should be set on Slave. The Roadman that is set on
Master takes the control over all other Roadman
(Volume control, switch ON/OFF etc.)
VOLUME
10
Control of Slave Speakers
RCA OUTPUT
11
Allows line level output for recording or any other
use
RCA INPUT
12
Allows the connection of any line level device
MASTER
13
General volume control of the system
TREBLE
14
TREBLE / HIGH TONE Equalizer
SYSTEM SETTINGS AND OPERATIONS:
BASS
15
BASS / LOW TONE Equalizer
LINE
16
Line Input (12) volume controller
MIC 1
17
Microphone 1 (20) volume controller
MIC2
18
Microphone 2 (22) volume controller
TAPE
19
Tape volume controller
MIC/LINE
20
Microphone or Line Input 1. Accepts Jack or XLR
connectors.
SPEECH/MUSIC
21
SPEECH: Microphone Input Level
Music: Line Input Level
MIC/LINE
22
Microphone or Line Input 2. Accepts Jack or XLR
connectors.
SPEECH/MUSIC
23
SPEECH = MIC: Microphone Input Level
Music = LINE: Line Input Level
LINK INPUT
24
This Input allows you to connect a Roadman to
another Roadman. The Link Input of the Slave Road-
man should be connected to the Link Output of the
Master Roadman.
CHARGING / LOW BATT
25
LED Indicator: Low Battery power (red), battery
charging (green blinking), battery fully charged
(green).
LED INDICATOR
26
When red, the system is in operation. Turned ON.
13
13