Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7
Set the desired maximum temperature with the + and - buttons.
8
Press the OK button to confirm.
The message 'Saved' appears on the display.
,
Temperature alert on/off
Note: You can only switch the temperature alert on and off in the menu of the parent unit.
Note: If the temperature alert is activated too often, reduce the set minimum temperature and/or
increase the set maximum temperature (see 'Setting room temperature range').
If the temperature alert is switched on, the parent unit beeps if the actual room temperature
exceeds the set maximum temperature or drops below the set minimum temperature. In addition,
the backlight of the parent unit display goes on and 'High' or 'Low' appears on the display. If no
minimum and maximum temperatures have been set, the temperature alert is given when the room
temperature drops below 57°F (14°C) or rises above 86°F (30°C).
1
Select 'Temperature' with the + and - buttons (Fig. 32).
2
Press the OK button to confirm.
3
Select 'Alert' with the + and - buttons (Fig. 32).
4
Press the OK button to confirm.
5
If the alert is off, the display shows 'On?'. Press the OK button to switch on the alert. If the
alert is on, the display shows 'Off?'. Press the OK button to switch off the alert.
Setting temperature scale
Note: You can only set the temperature scale in the menu of the parent unit.
You can set the temperature scale either to Celsius (C) or Fahrenheit (F).
1
Select 'Settings' with the + and - buttons (Fig. 32).
2
Press the OK button to confirm.
3
Select 'Temp scale' with the + and - buttons.
4
Press the OK button to confirm.
5
Select 'Celsius' or 'Fahrenheit' with the + and - buttons.
reset function
This function in the menu of the parent unit allows you to reset both the parent unit and the baby
unit to the default settings at the same time. You can use this function if problems occur that you
cannot solve by following the suggestions in chapter 'Frequently asked questions'.
1
Select 'Settings' with the + and - buttons (Fig. 32).
2
Press the OK button to confirm.
3
Select 'Reset' with the + and - buttons.
4
Press the OK button to confirm.
The message 'Confirm?' appears on the display of the parent unit.
,
5
Press the OK button to confirm.
The parent unit switches off and then switches on again.
,
The units have now both been reset to the default factory settings.
,
Default settings
Parent unit
-
Language: English
EngliSh
17
Publicité
Table des Matières
