SATA HRS Mode D'emploi page 32

Operating Instructions SATA HRS
EN
the air connection [1-12]
■ Start the pressurized cup spray gun by pressing the trigger guard [1-11]
.
■ Clean the pressurized cup spray gun and wand after use (see chap-
ter 12.2).
10.2. Check the fan pattern
The fan pattern must be checked regularly together with the wand to
warrant a perfect fan pattern. This can be carried out by spraying onto
paper or another suitable surface. The fan pattern must show a uniform
distribution of material, surrounded by fine spray mist. If the fan pattern is
incorrect, clean the wand (see chapter 12.2) or adjust the input pressure
(see chapter 7).
10.3. Adjust the fan pattern (only in version with flow con-
trol)
The flow control nut [1-21] can be used to adjust the material flow and
thus also the fan pattern. The flow needs to be adjusted depending on
the viscosity of the material being used. For materials with high viscosity,
the flow control nut usually has to be unscrewed further than for materials
with low viscosity.
■ Turning the flow control nut [1-21] to the left increases the material flow.
■ Turning the flow control nut [1-21] to the right reduces the material flow.
■ Lock the corresponding setting with a counter nut [1-20].
10.4. Refill material
Remove the pressurized cup
■ Disconnect the compressed air supply to the pressurized cup spray
gun.
■ Unscrew the pressurized cup [1-4] / [1-7] / [1-13]; in doing so, the pres-
surized cup spray gun is also vented at the cup thread.
■ Fill the pressurized cup with material.
For version HRS-E
■ Place the material container in the pressurized cup [1-4].
Fit the pressurized cup
■ Screw on the pressurized cup [1-4] / [1-7] / [1-13].
■ Vent the pressurized cup spray gun.
32