SATA HRS Mode D'emploi page 27

2.4. Safety Instructions
Technical status
■ Check the functions and check the pressurized cup spray gun for any
leaks every time before it is used.
■ Do a visual inspection of the pressurized cup to check for any signs of
damage or deformation.
■ Never use the pressurized cup spray gun when damaged or when
components are missing.
■ Always replace plastic pressurized caps after 2 years of use.
■ When damaged, stop using the pressurized cup spray gun immediately
and disconnect it from the compressed air circuit.
■ Adhere to safety regulations.
Cleaning agents for cleaning the pressurized cup spray gun
■ Never use acidic or alkaline cleaning agents to clean the pressurized
cup spray gun.
■ Never use cleaning agents based on halogenated hydrocarbons.
■ Check the cleaning agents with the manufacturer of the chemicals that
you are using.
Processing agents
■ When processing cleaning agents such as cleaners for vehicle exhaust
systems, only use the version with plastic pressurized cup.
■ When processing preservatives, such as wax or underbody protection,
give preference to the version with aluminium pressurized cup.
Connected components
■ Only use original SATA spare parts and accessories.
■ The connected hoses and lines must reliably withstand the thermal,
chemical and mechanical loads expected when using the pressurized
cup spray gun.
■ When pressurized hoses work loose, their whip-like movements can
cause injuries. Always vent the hoses completely before they are loos-
ened.
Point of use
■ Never use the pressurized cup spray gun in the vicinity of ignition sourc-
es, such as naked flames, burning cigarettes or non-explosion-proof
electrical equipment.
General
■ Never point the pressurized cup spray gun at human beings.
Operating Instructions SATA HRS
EN
27