SATA HRS Mode D'emploi page 31

10.1. Operation
Risk of injury from the wand whipping around
In combination with the compressed air, the material being sprayed can
cause the wands to whip around and cause injuries.
→ Before pressing the trigger guard, hold the wands securely and se-
cure them to prevent them from whipping.
Damage from using the wrong cleaning agents to clean the
pressurized cup spray gun
The pressurized cup spray gun can be damaged by using aggressive
cleaning agents to clean it.
→ Do not use aggressive cleaning agents.
→ Use neutral cleaning agents with a pH of 6 – 8.
→ Do not use acids, caustic solutions, bases, paint strippers, unsuitable
regenerates or other aggressive cleaning agents.
→ Check the used cleaning agents with the manufacturer of the chemi-
cals that you are using.
Notice!
Only use plastic pressurized cups when processing cleaning agents.
Give preference to aluminium pressurized cups when processing pre-
servatives.
■ Unscrew the pressurized cup [1-4] / [1-7] / [1-13].
■ Fill material into the pressurized cup.
For version HRS-E
■ Place the material container in the pressurized cup.
■ Insert the riser [1-3] into the material container.
■ Screw on the pressurized cup.
■ Connect the corresponding wand at the quick coupling[1-15].
■ Connect the pressurized cup spray gun to the compressed air circuit at
Operating Instructions SATA HRS
Warning!
Attention!
EN
31