Glass Door Installation And Removal; Log Placement - Napoleon GDS25N Instructions D'installation Et D'opération

5.3

GLASS DOOR INSTALLATION AND REMOVAL

Remove safety barrier.
A.
Lift the top cast piece off of the appliance.
B.
Pull handle and rotate 90°.
C.
Slide the door straight up to remove.
D.
Follow the above steps in reverse in order to reinstall the door.
Ensure that the bottom of the door engages the door retainer before
closing the latches.
5.4

LOG PLACEMENT

LOGS MUST BE PLACED IN THE EXACT LOCATION IN APPLIANCE. DO NOT CHANGE FROM THE
PROPER LOG POSITIONS. APPLIANCE MAY NOT FUNCTION PROPERLY.
It is not necessary to remove the cast front, however, this will make for a more simple log installation.
In order to assemble the log set, the glass door must be removed, see "CAST FRONT / GLASS DOOR
INSTALLATION AND REMOVAL" section.
LOG LOCATING SCREWS
DO NOT USE SUBSTITUTE MATERIALS.
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
WARNING
!
DOOR
WARNING
!
Place the rear log, as shown, onto the rear
A.
log support brackets. Ensure the cutout on
the left underside of the log, fi ts over the pilot-
assembly. Bend the bracket on the left side to
help retain the rear log.
3
LATCHES
2
BRACKET
W415-1332 / A / 11.21.14
27
EN