Finishing; Cast Front Installation And Removal; Safety Barrier Installation And Removal - Napoleon GDS25N Instructions D'installation Et D'opération

26

5.0 FINISHING

EN
DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASS
5.1

CAST FRONT INSTALLATION AND REMOVAL

Remove safety barrier.
A.
Lift the top cast piece off of
B.
the appliance.
Detach the front cast piece
C.
from the side pieces by
removing the screws from
the brackets located in the
upper inside corners.
Slide the front straight up to
D.
remove.
Follow the above steps in reverse
in order to reinstall the cast front.
Ensure that the tabs on the
underside of the front fi t behind the
front legs.
NOTE: It is not necessary to
remove the cast front, in order to
remove the door.
5.2

SAFETY BARRIER INSTALLATION AND REMOVAL

A barrier designed to reduce the risk of burns from the hot viewing glass, is provided with the
appliance and shall be installed.
Lift the top casting up and remove the safety barrier. Remove and discard plastic.
A.
Tilt the top of the safety barrier and hook under the top casting, make sure to hold the safety barrier.
B.
Slightly lift the bottom of the safety barrier and push onto the unit. Careful not to scratch the bottom
C.
casting.
Reverse these steps to remove.
D.
W415-1332 / A / 11.21.14
NEVER OBSTRUCT THE FRONT OPENING OF THE APPLIANCE.
REMOVED, CRACKED, BROKEN OR SCRATCHED.
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
3
FRONT
WARNING
!
RISK OF FIRE!
WARNING
!
2
SCREWS
BRACKET
FRONT
TAB
DOOR
RETAINER
72.4
FRONT
LEGS