Resistance Measurements; Diodetest - Klein Tools MM600 Manuel D'utilisation

ENGLISH

RESISTANCE MEASUREMENTS

1. Insert RED test lead into V jack
into COM jack
Continuity/Resistance/Diode
NOTE: The meter defaults to Continuity testing in this mode. To
enter Resistance testing mode, press the "SEL" button
The Resistance icon will appear on the display.
2. Remove power from circuit.
3. Measure resistance by connecting test leads to circuit. The
meter will auto-range to display the measurement in the most
appropriate range.
NOTE: When in a Resistance setting and the test leads are open
(not connected across a resistor), or when a failed resistor is under
test, the display will indicate O.L. This is normal.
DO NOT attempt to measure resistance on a live circuit.
DIODE TEST
1. Insert RED test lead into V jack
into COM jack
Continuity/Resistance/Diode
NOTE: The meter defaults to Continuity testing in this mode. To
enter Diode testing mode, press the "SEL" button
Diode icon
2. Touch test leads to diode. A reading of 200-700mV on display
indicates forward bias, "OL" indicates reverse bias. An open
device will show "OL" in both polarities. A shorted device will
show approximately 0mV.
14
OPERATING INSTRUCTIONS
, and rotate function selector switch
4
Black lead Red lead
, and rotate function selector switch
4
will appear on the display.
Black lead Red lead
, and BLACK test lead
5
setting.
, and BLACK test lead
5
setting.
11
to the
2
once.
11
to the
2
twice. The