Klein Tools MM600 Manuel D'utilisation page 11

AC/DC VOLTAGE (LESS THAN 1000V)
1. Insert RED test lead into V jack
COM jack
setting.
NOTE: The meter defaults to AC measurement. Press the "SEL"
button to toggle between AC and DC modes. The AC or DC icon
11
on the LCD indicates which mode is selected.
2. Apply test leads to the circuit to be tested to measure voltage.
The meter will auto-range to display the measurement in the
most appropriate range.
NOTE: If "–" appears on the LCD, the test leads are being applied
to the circuit in reverse polarity. Swap the position of the leads to
correct this.
NOTE: When in a voltage setting and the test leads are open,
readings of order mV may appear on the display. This is noise and
is normal. By touching the test leads together to close the circuit
the meter will measure zero volts.
AC/DC CURRENT
NOTE: The meter defaults to AC measurement. To measure DC, press
the "SEL" button
DC icon on the LCD indicates which mode is selected.
1. Attach test leads to the appropriate jacks and rotate function
selector switch
OPERATING INSTRUCTIONS
, and rotate function selector switch
4
Black lead Red lead
to toggle between AC and DC modes. The AC
11
to the appropriate setting as follows:
2
, and BLACK test lead into
5
the V
2
11