Klein Tools MM600 Manuel D'utilisation page 12

ENGLISH
• For AC/DC currents >400mA and <10A: Insert RED test lead into
10A jack
3
function selector switch
Red lead
• For mA AC/DC currents <400mA: Insert RED test lead into
mA/µA jack
rotate function selector switch
• For µA DC currents <400µA: Insert RED test lead into
A/mA jack
rotate function selector switch
2. To measure current: Remove power from circuit, open circuit at
measurement point, connect meter in-series in the circuit using
the test leads, and apply power to circuit.The meter will auto-
range to display the measurement in the most appropriate range.
Do not attempt to measure more than 10A.
When measuring currents greater than 6A, a measurement
time of 30 seconds followed by 10 minutes of recovery time
is recommended.
12
OPERATING INSTRUCTIONS
, and BLACK test lead into COM jack
2
Black lead
, and BLACK test lead into COM jack
6
Red lead Black lead
, and BLACK test lead into COM jack
6
Red lead Black lead
to the 10A AC/DC
to the mA AC/DC
2
to the µA AC/DC
2
, and rotate
4
setting.
, and
4
setting.
, and
4
setting.