Operation - Ryobi CFS1503 Manuel D'utilisation

WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
A lways wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
 Sanding on wood surfaces
 Removing rust from and sanding steel surfaces
 Polishing and scrubbing porcelain and metal
SANDING SHEET SELECTION
Selecting the correct size grit and type sanding sheet is an
important step in achieving a high quality finish. Aluminum
oxide, silicon carbide, and other synthetic abrasives are best
for power sanding. Natural abrasives, such as flint and garnet
are too soft for economical use in power sanding.
In general, coarse grit will remove the most material and finer
grit will produce the best finish in all sanding operations. The
condition of the surface to be sanded will determine which
grit will do the job. If the surface is rough, start with a coarse
grit and sand until the surface is uniform. Medium grit may
ASSEMbLy
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.

OPERATION

then be used to remove scratches left by the coarser grit and
finer grit used for finishing of the surface. Always continue
sanding with each grit until surface is uniform.
Sheet/Pad
Heavy scrubbing pad
(Part no. CFS1501-36)
Light scrubbing pad
(Part no. CFS1501-37)
Polishing pad
(Part no. CFS1501-38)
60-grit sanding sheet
(Part no. CFS1501-33)
120-grit sanding sheet
(Part no. CFS1501-34)
240-grit sanding sheet
(Part no. CFS1501-35)
ATTACHING HOOk-AND-LOOP SANDING
SHEETS
See Figure 2, page 11.
 Unplug the sander.
 Align holes in hook-and-loop type sanding sheet with
holes in pad, then carefully press fuzzy side of the sand-
ing sheet against pad as tightly as possible.
NOTE: Hook-and-loop type sanding sheets can be
reused for the life of the sanding abrasive. It is rec-
ommended that you keep the sanding sheet back-
ing clean to provide for best adhesion. Clean the
sheet and hook-and-loop pad by brushing lightly
with a light brush.
ATTACHING THE DUST bAG
See Figure 3, page 11.
The dust bag provides a dust collection system for the sand-
er. Sanding dust is drawn up through the holes of the sanding
sheet and collected in the dust bag during sanding.
 Unplug the sander.
 Using a slight twisting motion, firmly slide dust bag as-
sembly over blower exhaust on sander.
8 - English
Recommended Use
Paint and rust removal
Light scrubbing and cleaning
Polishing
Coarse sanding
Light sanding
Finish sanding