Assembly; Operation - Ryobi P435 Manuel D'utilisation

WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict severe injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
APPLICATIONS
You may use this tool for the purposes listed below:
 Polishing and buffing cars, boats, RVs, personal watercraft,
motorcycles, hardwood floors, and large furniture
WARNING:
Battery tools are always in operating condition. Therefore,
switch should always be in the OFF ( O ) position when
not in use or carrying at your side, when installing
or removing the battery pack, and when installing or
removing accessories.

ASSEMBLY

WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible
serious personal injury.

OPERATION

TO INSTALL / REMOVE BATTERY PACK
See Figure 1, page 8.
 To install: Make sure the power switch is in the OFF ( O )
position.
 Place the battery pack in the tool.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured in the
tool before beginning operation.
 To remove: Put the power switch in the OFF ( O ) position
and depress the latches.
TURNING THE BUFFER / POLISHER ON/OFF
See Figure 2, page 8.
 To start the buffer/polisher, place the power switch in the
ON ( l ) position.
 To stop the buffer/polisher, place the power switch in the
OFF ( O ) position.
The tool's rotating base moves in random orbital motion.
The orbit diameter is 1/2 in.
PREPARE THE SURFACE
For best results, the surface should be clean and dry. Most
high-gloss surfaces can be cleaned with a mild soap and
water solution. For removal of stubborn dirt such as road
tar, grease, and bug stains, you can use a mild ammonia
solution such as that used in glass cleaners. Before using
any cleaning product, check the label for recommended
applications and follow the directions for use.
Never apply cleaner directly onto surface to be polished.
Apply to a clean cloth then use the cloth to clean the surface.
Do not use any type of abrasive cleanser as it may damage
or scratch the surface.
5 – English