Features
2
3
1
ON/OFF Button: Press and hold the POWER
1
this button will "cold-start" the UPS; i.e. turn it on and supply battery-derived power to the outlets.
MUTE/Select Button: Use this button to toggle power condition displays. Refer to Display UPS/Power Conditions section for details. This
2
button can also be used to place the unit in silent mode (mute the beeper completely) or to temporarily mute an active alarm by pressing
and holding until you hear an audible beep.
3
TEST Button: Press and hold this button and the UPS will begin a self-test lasting about 10 seconds.
Tel/DSL/NETWORK Line Protection Jacks: These jacks protect equipment against surges over a single phone line or network connection.
4
Connecting your equipment to these jacks is optional. Your UPS will work properly without this connection.
Coaxial Line Protection Jacks: These jacks protect equipment against surges over coaxial line. Connecting your equipment to these jacks
5
is optional. Your UPS will work properly without this connection.
USB Communication Port: This port can connect your UPS to any computer for automatic file saves and unattended shutdown in the event
6
of a power failure. Use with Tripp Lite's PowerAlert
USB cable. A USB cable is included with your UPS. This connection is optional. Your UPS will work properly without this connection.
Note: This UPS System provides basic communication compatibility with most integrated Windows
SURGE SUPPRESSION ONLY Outlets: These outlets offer premium surge suppression for accessories not requiring battery backup support.
7
These outlets are always energized when the UPS is connected to a live outlet, even if the UPS is turned off.
BATTERY BACKUP Outlets: These outlets offer battery backup support and premium surge suppression for critical devices requiring battery
8
backup support.
Note: Do not plug laser printers into the battery backup outlets.
Resettable Input Circuit Breaker: Protects your electrical circuit from overcurrent draw from the UPS load. If this breaker trips, remove
9
some of the load, then reset it by pressing it in.
4
5
7
BUTTON for one second to turn the UPS on and off. If utility power is not available, pressing
Software (available as a FREE download at www.tripplite.com/poweralert) and appropriate
®
8
, Macintosh
and Linux
power management applications.
®
®
®
6
8
9