Basic Operation; Ups On/Off - Tripp-Lite LCDT Serie Manuel Du Propriétaire

Basic Operation

UPS ON/OFF

• Plug the UPS into a live, grounded outlet.
The LCD display will illuminate, the battery charger will engage as necessary and the SURGE PROTECTED outlets will begin passing power.
• Plug equipment into the UPS: Your UPS is designed to support electronic equipment only. You will overload the UPS if the total volt-amp
(VA) ratings for all the equipment connected to the "Battery, Surge & Noise Protected" outlets exceed the UPS output capacity. To find your
equipment's VA ratings, look on their nameplates. If the equipment is listed in amps (A), multiply the number of amps by 120 to determine VA.
For example: 1A × 120 = 120VA.
• Turn the UPS on: Press and hold the POWER
The BATTERY/SURGE PROTECTED outlets will begin passing AC line power. The UPS will automatically recharge internal batteries as needed.
Once turned on, your UPS is ready to protect connected equipment from blackouts, brownouts, overvoltages and transient surges.
• Turn the UPS off: Press and hold the POWER
BUTTON for one second. The UPS alarm will beep once briefly.
BUTTON for one second.
4