Quick Installation; Optional Installation - Tripp-Lite LCDT Serie Manuel Du Propriétaire

Quick Installation

STEP 1: Plug the UPS into a properly grounded outlet.
After plugging the UPS into a wall outlet, press and hold the POWER
second to turn on the UPS (See Basic Operation Section).
Notes :
• The UPS will not turn on automatically in the presence of live utility power.
• UPS system will function properly upon initial startup; however, maximum runtime for the unit's battery will
only be accessible after it has been charged for 24 hours.
STEP 2: Plug your equipment into the UPS.
There are two sets of outlets on the back of your UPS. Outlets marked SURGE PROTECTED
do not provide battery backup power during power outages. Connect common desktop items
like printers, scanners and other accessories not requiring battery support to these outlets.
Outlets marked BATTERY/SURGE PROTECTED
failures. Connect your vital computer equipment into these outlets.
Your UPS is designed to support electronic equipment only. You will overload the UPS if the
total volt-amp (VA) ratings for all the equipment connected to the "Battery, Surge & Noise
Protected" outlets exceed the UPS output capacity. To find your equipment's VA ratings, look
on their nameplates. If the equipment is listed in amps (A), multiply the number of amps by
120 to determine VA. For example: 1A × 120 = 120VA. If you suspect you have overloaded
the outlets, check the Load Percentage and Load Meter screens (see Display UPS/Power
Conditions in Basic Operation). If you are still unsure, run a self-test (see Self-Test in Basic
Operation).

Optional Installation

All models include USB communication ports, tel/DSL/Ethernet (not compatible with PoE
applications) surge protection jacks and coaxial line protection jacks. These connections
are optional; the UPS will work properly without these connections. See the connector's
description in the Basic Operation section for connection instructions.
If the on-line AC power icon
following:
1. Make sure that the UPS is plugged into a live AC outlet.
2. Press and hold the POWER
sound when the UPS starts.
3. If the UPS still does not start, contact Tripp Lite Tech Support for assistance.
offer UPS battery backup support during power
does not illuminate when the UPS is turned ON, try the
BUTTON for one second to turn on the UPS. A beep should
BUTTON for one
3