Quick Installation - Tripp-Lite OMNIVSX450D Manuel D'utilisation

Important Safety Instructions
UPS and Battery Recycling
Please recycle Tripp Lite Products. The batteries used in Tripp Lite products are sealed lead acid batteries. These batteries are highly
recyclable. Please refer to local codes for disposal requirements.
Call Tripp Lite for recycling info at +1.773.869.1234.
Go to the Tripp Lite Website for up-to-date information on recycling the batteries or any Tripp Lite product.
Please follow this link: http://www.tripplite.com/support/recycling-program/

Quick Installation

STEP 1: Plug the UPS into
a properly grounded outlet.
After plugging the UPS into a wall outlet, press the power
button to turn on the UPS (See Basic Operation).
Note: The UPS will not turn on automatically in the presence of live
utility power.
STEP 2: Plug your equipment into
the UPS.
Outlets marked BATTERY & SURGE offer UPS battery backup
support during power failures. Connect your vital computer
equipment into these outlets.
Your UPS is designed to support electronic equipment only.
You will overload the UPS if the total volt-amp (VA) ratings
for all the equipment connected to the BATTERY/SURGE
PROTECTED outlets exceed the UPS output capacity. To find
your equipment's VA ratings, look on their nameplates. If the
equipment is listed in amps (A), multiply the number of amps
by 230 to determine VA. For example: 1A × 230 = 230VA.
If you suspect you have overloaded the outlets, check Load
Meter screens (see Display UPS/Power Conditions in Basic
Operation).
If the on-line AC power icon
UPS is turned ON, try the following:
1. Make sure that the UPS is plugged into a live AC outlet.
2. Press the power button
should sound when the UPS starts.
3. If the UPS still does not start, contact Tripp Lite Tech
Support for assistance.
does not illuminate when the
to turn on the UPS. A beep
OMNIVSX450 / OMNIVSX650
OMNIVSX450 / OMNIVSX650
3
OMNIVSX450D / OMNIVSX650D
OMNIVSX450D / OMNIVSX650D