Other Indications - Aircare MA0800CN Manuel D'utilisation Et D'entretien

REFILL INDICATION
When both the bottle and the base are empty, the display alternates
the room humidity reading and "F" indicating additional water is
required. At this time and refill unit according to the instructions in the
WATER FILL section.
AUTO DRYOUT
If unit is not refilled shortly, time the unit will automatically switch into AUTO DRY
OUT MODE and continue to run on the lowest speed until the filter is completely
dry.The fan will shut off leaving you with a dry humidifier that is less prone to mold
and mildew.

OTHER INDICATIONS

CHECK FILTER INDICATOR
The ability of any humidifier to efficiently supply humidity output
relies heavily on the condition of the filter. As the wicking filter loads
with impurities it gradually loses its wicking capability. When this happens, moisture
output is reduced and the humidifier has to work longer to satisfy the selected
setting.
This humidifier has a check filter reminder timed to appear after 720 hours of
operation. When the display shows an alternating "CF" and "room humidity" setting
at 5 second intervals it is a reminder to check the filter condition.
NOTE: Some areas have high water mineral content causing the need for more
Frequent wicking filter changes.
Reset the Check Filter "CF" function each time you replace a filter by unplugging
the unit from the power source, then plug it in again.
Refer to REPLACEMENT OF WICKING FILTER if a build-up of deposits or severe
discoloration is evident replace wick to restore maximum efficiency.
CONTROL LOCK FEATURE
To avoid unwanted tampering with the humidifier settings the
controls can be locked.
ACTIVATION PROCEDURE
After the humidifier functions have been set up, hold the power button down for 5
seconds. The display will show "CL" for 2 seconds; release the power button and
the control will resume the display of the room humidity. The humidifier will continue
to function with the locked in settings. If buttons are operated while "CL" is active,
the "CL" is displayed and settings are unaffected.
DEACTIVATION PROCEDURE
To deactivate the "CL" function simply press and hold the power button for 5
seconds. "CL" will flash at the rate of 1 second on and 1 second off for a period of 2
seconds and then resume the display of room humid
7