General Information; Applicable Standards, Field Of Application, Cautions And Warnings - DPI Sekur C607 Serie Manuel D'utilisation Et D'entretien

1

General information

D.P.I. s.r.l. has carefully worded and edited this instruction manual. However, in no event
shall D.P.I. s.r.l. be liable for any damage caused by misunderstandings of the text,
misprints or incompleteness. SEKUR is the registered trademark of the personal
protective equipment manufactured by D.P.I. s.r.l. Technical alterations of this
equipment are not allowed.
1.1 Before using SEKUR C607 masks, users must ensure that all the instructions in this
manual are read, understood and followed.
1.2 SEKUR masks have been specifically designed for the use described in this manual.
1.3 Repair and replacement of spare parts must be carried out by trained personnel,
using original SEKUR spare parts.
1.4 It is advisable for all periodic mask testing to be carried out by D.P.I. s.r.l. technical
service or by other trained personnel qualified for this purpose, according to the
instructions of the appropriate paragraph.
1.5 The D.P.I. s.r.l. standard warranty indicates the full extent of the liability of D.P.I.
s.r.l.. D.P.I. s.r.l. will not accept liability for any damages caused by:
a) testing which has not been carried out;
b) testing and maintenance improperly carried out by persons other than those
qualified to do so by D.P.I. s.r.l.;
c) improper usage of the mask.
1.6 D.P.I. s.r.l. will not accept liability for any damages caused by failure to abide by the
aforementioned provisions.
1.7 For everything which has not been mentioned above, the general conditions of this
warranty apply. In the event that you don't know the conditions of the contract,
D.P.I. s.r.l. will send further information upon written request.
1.8 The products Declaration of Conformity is available on the web site
www.dpisekur.com in the specific section
2

Applicable standards, field of application, cautions and warnings

C607 masks are PPE belonging to the III category according to the European Regulation
2016/425, and they conform to the requirements specified in the with EN 136:98 Norm;
they are equipped with standard threaded according to the Norms EN 148-1 and EN 148-
3 (see table). C607 Twin is equipped with special threaded connectors designed for use
with two Sekur filters of the 200 series. Testing according to the relevant Norms,
certification and authorisation to CE marking have been performed by the following
Notified bodies:
C607 E SIL
C607 E
C607 SP/A SIL
C607 SP/A
C607 SP/A ESA SIL
C607 SP/A ESA
C607 SP/A ATEX SIL
C607 SP/A ATEX
(4333.2037)
(4333.2034)
(4333.3008)
(4333.3007)
(4333.2022)
(4333.2028)
(4201.0658)
(4201.0657)
19
Italcert - Viale Sarca, 336
20126 Milano - Italy
(Notified Body n. 0426)