Programming; To Erase All Codes; To Add Or Reprogram A Hand-Held Remote Control; Using The Door Control - Craftsman 139.18489DS Manuel D'instructions

PROGRAMMING

NOTICE: If this Security ✚
®
the garage door opener, which provides security against code-theft devices, will be circumvented. The owner of the copyright in the
garage door opener does not authorize the purchaser or supplier of the non-rolling code transmitter to circumvent that technical
measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control. The door will
open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security✚
USING THE "LEARN" BUTTON
1. Press and release the "learn" button on the
motor unit. The learn indicator light will
glow steadily for 30 seconds.
2. Within 30 seconds, press and hold the
button on the hand-held remote* that you
wish to operate your garage door.
3. Release the button when the motor unit
lights blink. It has learned the code. If light
bulbs are not installed, two clicks will be
heard.
To Erase All Codes From Motor Unit Memory
To deactivate any unwanted remote, first erase all codes:
Press and hold the "learn" button on motor
unit until the learn indicator light goes out
(approximately 6 seconds). All previous
codes are now erased. Reprogram each
remote or keyless entry you wish to use.
garage door opener is operated with a non-rolling code transmitter, the technical measure in the receiver of

To Add or Reprogram a Hand-held Remote Control

®
315 MHz remote controls.

USING THE DOOR CONTROL

1. Press and hold the button on the
hand-held remote* that you wish to
operate your garage door.
2. While holding the remote button, press
and hold the LIGHT button on the door
control.
3. Continue holding both buttons while you
press the push bar on the door control (all
three buttons are held).
4. Release buttons when the motor unit lights
blink. It has learned the code. If light bulbs
are not installed, two clicks will be heard.
*3-Function Remotes (315 MHz)
If provided with your garage door opener, the large button is
factory programmed to operate it. Additional buttons on any
®
Security✚ 3-Function remote
or compact remote can be
programmed to operate other
Security✚ ® garage door
openers.
35