Component Names - NSK Varios 570 Mode D'emploi

* Operation Principle
A sinusoidal electrical signal, at ultrasonic frequency ( f > 20kHz ) , is delivered by the generator. This signal is applied
to the 'piezoelectric ceramic' located inside the transducer. Piezoelectric ceramic converts this signal into mechanical
vibrations. These vibrations are at the same ultrasonic frequency as the electrical signal. The mechanical vibrations
are propagated towards the distal end of the transducer. The "TIP" insert, which is attached at the distal end of the
transducer, vibrates at ultrasonic frequencies and makes it possible to achieve the aimed purpose.

2. Component Names

DC Plug
1 Control Unit
2 Handpiece with Handpiece Cord Unshield 2M
( Varios2 or Varios2 Lux )
3 1 AC Adaptor Unshield cord 2M
4 Foot Control
5 Water Tube Set
Tip ( G4,G6, G8 )
6
7 Tip Wrench
Spanner Wrench ( 5x8 )
8
9 O Ring
10 Tip Cover S ( Option )
11 Tip Holder ( Option )
By an area, AC Adaptor Shape change
1
Either one is contained with the set that you purchased
2
120 V Only
3
3
* 3
1
2
1
1
1
1
1
1
2
2
-
-