FISCHER 18092 Mode D'emploi page 38

Step 11
Lower the carrying unit from the vehicle roof onto the vehicle side
1. Loosen the hand wheel (1f) left and right (do
not screw off completely!). Hold the carrying
unit on the left and right near the foam
profile (2b) and push the safety clamps (2a)
down with your thumb.
2. Pull the carrying unit forward until the front
guide rollers (1c) stop in the guide rails.
Remove the front guide rollers (1c) from
the openings in the guide rail by lifting the
carrying unit slightly, pull forward and place
in front of the guide rails.
38
18092_Betriebsanleitung_D_GB_F_IT_PL.indd 38
3. Pull the carrying unit further forward until
the front guide rollers (1d) stop in the guide
rail and lower slowly until the foam profile
(2b) is resting on the side of the vehicle.
nOTe:
Check the foam profile before
resting to make sure it is clean.
13.02.15 11:25